Purchasing Options
-
Can I get a special sized desktop?
We currently do not have the capacity to offer this service. Since the Covid-19 outbreak we have been inundated with orders and this a bespoke item that is time consuming to make. Unfortunately we do not have the machine time nor manpower currently to offer bespoke sizes. We hope offer this aga... -
Can I have a 25mm thick top and not an 18mm thick top?
Not any longer. We stopped manufacturing 25mm tops for a number of reasons: They are not needed for anything more than aesthetic reasons. 18mm tops are perfectly strong to hold the maximum allowable weight of the desk. With inserts we can hang up to 50Kg from underneath the desk. There is no use... -
Can I have a bespoke sized 90-degree desk?
We currently do not have the capacity to offer this service. Since the Covid-19 outbreak we have been inundated with orders and this a bespoke item that is time consuming to make. Unfortunately we do not have the machine time nor manpower currently to offer bespoke sizes. We hope to offer this ... -
Can I have cable port holes cut but not buy cable ports?
No. A large part of the cost of the cable ports is putting them on the CNC machine and cutting them. To have cable port holes and but no port covers simply order plastic cable ports and when your desk arrives remove them. -
During installation set the legs to their highest position and then fit the handle. This will allow you to put the handle in the correct position to fold away while the legs are at their highest position.
-
How far in is the cable tray positioned if I select pre-drilling/inserts?
The cable tray will be set approx 60mm from the back edge of the desk as standard unless a monitor arm is ordered with us in which case it will be positioned 90mm from the back edge of the desk. Should you wish to have your cable tray a specific distance away from the back edge then you can advi... -
How narrow/wide can I make my electric frame?
An electric frame can go down to 105cm at its narrowest setting. -
How narrow/wide can I make my manual frame?
A manual frame can go down to 115cm at its narrowest setting, although at this point the handle will come out further than the side of the desk by approx 100mm. -
Is an 18mm thick desk top strong enough to hold my dual monitors?
Yes the desk tops are strong enough for office use, a thicker desk top is not required. Our sit-stand desks have twin bars which run across underneath the desk to make the frame more stable. These provide significant support to the desk-top so it is not necessary to have a super thick top. -
What does handset location mean?
The handset is your controller for raising/lowering your desk. It can be positioned anywhere on the underneath of the desktop but is best positioned at the front edge for easier access. If you have your desktop inserted or pre-drilled, you can choose to have it on the far right- or left-hand side... -
What is the difference between Pre-Drilling and Metal Inserts?
Our standard desktops are sold blank, with no holes drilled in. You can still assemble this way and it's not very difficult, but you do need to pierce the hard top surface of the desk-top. Pre-drilling is when we drill small pilot holes in the underneath of the desktop to penetrate the hard surf... -
Where are the Cable Ports positioned?
We always position the centres 100mm from the back edge and 130/140mm from the side edge for 60/80mm Cable Ports.